How To Install Spacemaker™

PRODUCTS
SPECIAL OFFERS & PROMOTIONS
EXPIRIENCE THE DIFFERENCE
CUSTOMER SERVICE
PRESS ROOM
CONTACT US

Please subscribe to our newsletter to get special offers and promotions.

LAUNCH OUR INTERACTIVE TOOL KITCHEN WITH SPACEMAKER

Home > Experience > How to Install SpaceMaker™ appliances

Kitchen With SpaceMaker
Counter Space Calculator
How to Install SpaceMaker
Before and After SpaceMaker Gallery
Feng Shui Tips

Clear countertop under installation area to avoid getting dust or debris on other appliances or items. Open cabinets and remove contents to make mounting easier.

Important: Always wear protective glasses or goggles to prevent injury when drilling.

With cabinet doors open, place mounting template flush against the surface of the underside of your cabinet, making sure to align thick line on template with bottom front edge of your cabinet.

Important: Do not align screw holes on template with the partition between cabinets, as this will prevent you from installing the appliance properly. Pay close attention to where the drill holes will be set so as not to damage your cabinets during mounting. Drilling through your cabinet’s partition may cause damage to cabinets and prevent proper installation.

Once thick line is straight with bottom front edge, pull template tight and tape down on all 4 corners to hold in place.

Drilling from under the cabinet up, drill holes through the 4 places marked on the template, using a 1-inch drill bit .

Important: Always ensure you are drilling straight up through the marked mounting hole on the template. Drilling at an angle may prevent proper installation and may damage cabinets if the drill bit pierces the partition.

Once holes are drilled, remove tape and mounting template and save template with your instructions in case you move or wish to remount at a later time.

Wipe dust and debris off inside cabinet surface. Also, make sure under side of cabinet is clean.

Place a washer inside the cabinet over each of the 4 holes you drilled.

Hold appliance in place, aligning front of unit with front edge of cabinet; drilled holes on cabinet should be aligned with mounting holes on the unit.

Screwing from inside the cabinet down into appliance holes, tighten 4 screws in place to secure appliance to cabinet.

Note: Always tighten screws to ensure the appliance does not move or shake during operation.

Pull out cord from cord storage behind appliance and plug into standard electrical outlet. Extra cord can be fed back into storage or hung over cord management hook behind unit.

Note: If connecting multiple SpaceMaker™ appliances together, plug any 2-prong appliance into female receptacle at the rear of any 3-prong appliance.

Your SpaceMaker™ appliance is now ready for use!

BUY SPACEMAKER™ APPLIANCES

is a trademark of The Black & Decker Corporation, Towson, Maryland, USA | SPACEMAKER™ is a registered trademark of General Electric Company, USA